| Step | Photo | Duration |
|---|
| 1 | Warm milk to 86f(30c). Sprinkle 1/8th tsp. Kazu or Chr. Hansen 11-19 culture onto milk. Allow 5 minutes for culture to dissolve on the surface of the milk, then stir gently for a few minutes. | | 00:15:00 |
| 2 | Add rennet (do not use vegetable rennet). Cut curds into 1 inch pieces at the beginning of the clean break. Stir curds until they sink to the bottom of the vat, about 10 minutes, longer for higher fat milk. Add 1 gal.(1.9l) of water 176f(80c) to the vat. | | 00:15:00 |
| 3 | Stir gently for 10 minutes. The temperature should stabilize at 93f(33.8c), no higher than 94f. Allow curds to settle to bottom of vat for 10 minutes. | | 00:25:00 |
| 4 | Adjust the amount of water if your batch is more than 5 gallons of milk. Remove at least 1/3 of the whey replacing it with the same volume of water 111f(43.8c). Stir the curds to keep them from matting. Allow the curds to sit in the vat for another 20 minutes, stirring only to keep them from matting. The temperature should stabilize at 99-100f. | | 00:25:00 |
| 5 | Drain about 10-20% off the whey off the curds. With more room in the vat, place your sanitized hoop or mould in the vat, pushing aside any curds. Place the curds into the hoop/mould while it’s in the whey. | | 00:10:00 |
| 6 | Once all the curds are in the mould/hoop gently press down on the curd mass using your hands. Pour warm whey from the vat onto the curds 3-4 times, allowing the whey to move through the curds. Make sure the curds are evenly spread into the hoop/mould. | | 00:10:00 |
| 7 | Take the filled hoop/mould out of the vat and allow the whey to drain naturally for an hour or until the draining decreases. | | 01:00:00 |
| 8 | Dress in 50 or 60 grade cheese cloth and apply a light pressing(20lbs of weight) for another hour per side. Press again for one hour per side at a heavier pressing (40lbs of weight). Brine in heavy brine** for 12 hours for every 5 lbs (2.2 kg) of cheese. For small cheeses less than 5 lbs, brine for 8-10 hours. | | |
| 9 | Allow to air dry at room temperature until rind is dry. Use a small fan to dry the cheese faster. Use cream wax*(which includes mold inhibitor Natamax) and/or hard wax. Age at 50-55f(10-12.7c)/75-80% rH for two-three months. | | |
| 10 | Age on pine wood, bamboo or plastic matting and turn over daily for at least one week. Brush with light cloth if any unwanted mold appears. A solution of white vinegar and salt can also be used. | | |
